Where? Workstations at best.

I’m upgrading ASAP just for ROCM 6.2 because almost nothing seems to work ever since I’ve updated to 6.1.2 for some reason

TIL 1/3 of people don’t have Internet access

deleted by creator

Thanks. That’s a good ELI5. Fortunately I managed to make sense of it before your reply but the link to environment variables is highly appreciated. As I already replied to someone else, I had no idea PATH was a global/environment variable and just assumed it’s telling me to specify path so I had no idea I need to RTFM as it confused me greatly and on top of that I did another mistake which confused me even more when I finally managed to get it to do correctly which made me think I am doing it wrong.

I gave up at CMAKE finally as I really need to RTFM more on that as it started to throw many errors at me.

I’m fine with RTFM but I had no idea PATH is a global variable and I assumed it’s telling me to specify path to something. So I had no idea I need to RTFM because I did not RTFM to understand that I need to RTFM. After the first reply pointed me the right direction I managed to make sense of it. Though english is not my first language and some of the terms are just over my head so I had to RTFM with dictionary which took a lot of time for me to finally understand because I was doing another thing wrong on top of that which specifically was

I had to do ~/SCALE_PATH instead of the confusing example of $(SCALE_PATH} as trying nvcc --version did absolutely nothing even though the path was correct

I’ve been on Linux since April so I’ve stumbled a lot but got many things to work, it just takes me a lot of time to get trough it and I’ve really stumbled on this one. Getting ROCM to work was a breeze and most recently getting PyTorch with ROCM to work for AI generative models on AMD. I’ve also finally started to tinker with toolbox a lot more and finally understand the benefits of it.

Well, I progressed quite a bit and learned a lot more than I knew until now but I give up. This is way over my head, I’ll stick to using ROCM for now. Thanks for pointing me in the right direction at least.

Thanks, I’m still not sure I completely understand but I think this iis how it’s supposed to be

It’s slower because it runs at lower clocks

The point I’m trying to make is to your first response to CondensedPossum being that you’re still ruining a corporate LLM with bias.

Because if you did not then it doesn’t matter if you run it locally

Have you trained that LLM?

In that case there’s no downside then

Manjaro and Ubuntu surprised me how bad they are

Thanks!

1.) will definitely give it a try 3.) I have set the amdgpu feature mask otherwise I wouldn’t even have access to the power limit, voltages, etc… but VRAM overclocking just does not work. Everything else seems to work fine.

I’m 100% sure it’s not a cable issue for many different valid reasons one of the main ones being that the cable is able to drive higher res monitor at higher refresh rate without issue.

Also if I just swap cables from my main monitor with the 2nd the same issue still happens with the 2nd monitor but only in Linux, never Windows.

Please bear in mind that custom tuning isn’t a guarantee between different driver versions; the voltage floor can shift with power management firmware changes delivered driver packages (this doesn’t overwrite the board VBIOS, it’s loaded in at OS runtime (pmfw is also included in linux-firmware)). I’d recommend testing with vulkan memory test with each Adrenalin update, and every now and then on Fedora too.

I’m aware. For now it seems to behave consistently. I observed higher avg clocks on Linux vs Windows with the same OC but then again it may be due to difference in monitoring SW or just polling rate.

To be fair when it’s time to upgrade the Linux support will be probably even worse since I would be upgrading to even newer stuff than what I have now.